20 Comments

  1. marat tm on November 4, 2023 at 9:56 pm

    И гайку поменьше тоже надо было просверлить и вставить болтик ещё тоньше и гайку поменьше тоже надо было просверлить….



  2. OMG REXS on November 4, 2023 at 10:06 pm

    Para q mierda le hizo la rosca



  3. Track1productions on November 4, 2023 at 10:10 pm

    It’s a good thing you did that



  4. Ded Roy on November 4, 2023 at 10:11 pm

    Why wasn’t the small nut fixed?



  5. sereoga on November 4, 2023 at 10:15 pm

    В маленькой гайке надо просверлить дырку сунуть болт ещё меньше и закрутить гайкой



  6. Max Che on November 4, 2023 at 10:16 pm

    Шплинт? Не ,не слышал.



  7. Cassiano Mafra on November 4, 2023 at 10:18 pm

    Amei o vídeo que legal 😮😮



  8. Red_D on November 4, 2023 at 10:19 pm

    what the fuck was the point of the last two



  9. Sергий on November 4, 2023 at 10:22 pm

    А зачем сверлить болтик и гайку?



  10. Sonny Latchstring on November 4, 2023 at 10:24 pm

    Never understand why such foolishness gets so many LIKES?????? You’re ALL crazy, not just by watching, but by liking!!!



  11. Bucket Mouth on November 4, 2023 at 10:24 pm

    Next: How to make an upside down cake, right side up.



  12. oni luis on November 4, 2023 at 10:26 pm

    god forbids you work close on any woodcraft



  13. chris U on November 4, 2023 at 10:40 pm

    How did those threads work out in that 2×4 you stuffed a plug into?



  14. Frame Drop on November 4, 2023 at 10:42 pm

    木工でネジの長さも考えないバカいるの？(笑)



  15. Tim Schotte on November 4, 2023 at 10:43 pm

    Wenn man nicht richtig verschrauben kann, dann sollte man es besser sein lassen. 😊



  16. craig hill on November 4, 2023 at 10:45 pm

    what is yhe point of putting a thread on a dowel if your going ti usexa hammrr to knock it in



  17. mac876plus on November 4, 2023 at 10:47 pm

    ビットがいいじゃん！



  18. WIND IN THE WIRE on November 4, 2023 at 10:52 pm

    I have a hole in my shoe.!



  19. dominator on November 4, 2023 at 10:54 pm

    It’s hilarious how this channel believes that you must hammer screws in



  20. keetano on November 4, 2023 at 10:54 pm

    waste of time